Blanks For Blank IPhone 13 Case for sublimation with Glass Insert by INNOSUB USA

About this item

• Sublimation Blanks Phone Case with Tempered Glass Wireless Charging Compatible Insert for iPhone13, Soft Rubber Protective Shockproof Case Anti-Slip Printable DIY
• INNOSUB USA Blank Cases for iPhone models
  Protective Soft Rubber case/ Hard Plastic Case.
  Double-sided 3M tape 
  Each Case includes High quality Glass Insert+Plastic sleeve. 

• Pressing instructions: Remove the protective film from the back of the glass, print your image without mirroring, place the glass over your image.

• Glass inserts: 176-187 degrees Celsius

• (350-360 degrees Fahrenheit) for 60 seconds

  Note: Depending on your heat-press, your pressing time and temperature might vary, and we recommend that you start pressing with low settings and add more if needed. After you are done pressing, don’t take the tape out, lift the side of the insert without detaching it from the paper, check if fully sublimated, If not, press again.